Which layer of the TCP/IP model corresponds to the OSI network layer? MCQ with Answer and Explanation

Question
Which layer of the TCP/IP model corresponds to the OSI network layer?
A. Transport layer
B. Application layer
C. Internet layer
D. Link layer
Answer: Option C
Solution (By JKSSB Mock Tests)
In TCP/IP, the Internet layer corresponds to the OSI network layer, handling routing and IP.
This question belongs to: Computer Computer Networking
Request complete Subject PDF

Discuss this Question (0)

No comments yet. Be the first to start the discussion!

Practice More Computer Networking Questions

Question #1
What happens if a single computer loses power or its connection cable breaks in a standard unidirectional Ring Network configuration?
A. The network splits into two fully operational sub-rings.
B. The remaining devices shift to a bus topology configuration automatically.
C. The entire network communication path is broken, stopping traffic across the ring.
D. Data frames loop back through the gateway interface.
Discuss
Get Complete Subject PDF for Computer

Correct Answer: Option C

Explanation:
Because data travels sequentially from node to node around a ring topology, any break in the link disrupts the circuit and stops all network traffic.
This question belongs to: Computer Computer Networking
Question #2
Which of the following is an example of a Class C IP address based on the traditional classful addressing scheme?
A. 10.0.0.5
B. 172.16.254.1
C. 192.168.1.50
D. 240.0.0.1
Discuss
Get Complete Subject PDF for Computer

Correct Answer: Option C

Explanation:
Class C IP addresses have a first octet range spanning from 192 to 223, commonly used for small local area networks.
This question belongs to: Computer Computer Networking
Question #3
Which address space can be used by any network client to check the internal functionality of its own TCP/IP network protocol software stack?
A. 255.255.255.255
B. 192.168.1.1
C. 127.0.0.1
D. 0.0.0.0
Discuss
Get Complete Subject PDF for Computer

Correct Answer: Option C

Explanation:
127.0.0.1 is the standard loopback address. It lets a device route diagnostic traffic back through its internal software layer without hitting physical network lines.
This question belongs to: Computer Computer Networking
Explore All Computer Networking MCQs
Today's Top Topics
Computer Abbreviations 369 Memory and Storage Devices 438 Computer Fundamentals 326 Programming Languages 0 Operating Systems 510
Explore Subjects
Maths 5575 English 15164 Science 4430 Static General Knowledge 6362 Economy GK 2220
Practice Mix
Milk and water are in ratio 4:6 in a 273 L mixture. Quantity of milk?
The blaze ______ they doused was huge.
The 'Rani of Jhansi' is associated with:
The posters were ________ all over the city.
The principal that gives Rs. 453600 interest in 8 years at 9% SI is